lap joint
英 [læp dʒɔɪnt]
美 [læp dʒɔɪnt]
（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝
英英释义
noun
- joint made by overlapping two ends and joining them together
双语例句
- Most scholars mainly adopted one dimension variation analysis model, and took qualitative analysis on the butt joint, lap joint of the parts in the research field of assembly sequence optimization which targets was dimension quality.
以装配尺寸质量为目标的装配顺序优化研究方面，多数学者主要采用一维的偏差分析模型，对零件间的对接、搭接等接头形式进行定性分析。 - The shear strength and elongation of the lap joint increase with the increase of strain rate.
焊点的剪切强度及伸长量随应变速率的增加而增加。 - Numerical analysis on stress distribution in single lap joint with a metal inlay
含镶嵌块单搭接接头应力分布的数值分析 - The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。 - A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。 - When the composites are lapped in the simple way, the lap joint length has no influence on the tensile strength, but it has influence on the breaking elongation and the yield strength.
简单搭接的拉伸强度与搭接长度无关，但对屈服强度和断裂伸长率有影响。 - By comparing the results of buckling analysis, the effects of material nonlinearity, geometric imperfection and lap joint on stability were studied.
分析了材料非线性、几何缺陷和筒壁搭接对稳定性能的影响。 - Using boundary element method, the interfacial streeses of adhensive lap joint with either perfect or imperfect interface are studied.
采用边界元法计算分析了具有理想界面和非理想界面的双板条胶合搭接连接的界面应力。 - The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。 - Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。